Fuji Electric Announces Smaller, Lighter Automotive IGBT Module

2014/06/05 21:08
Tadashi Nezu, Nikkei Electronics
Print Page

Fuji Electric Co Ltd introduced directly-water-cooled IGBT power modules for electric vehicles including hybrid cars at PCIM Europe 2014.

This time, the company announced (1) the technologies used for a module employed for a commercially-available vehicle and (2) a next-generation module that is smaller and lighter than it.

Module employed for commercially-available vehicle
The most distinguished feature of the module employed for the commercially-available vehicle is that aluminum (Al) is used for its heat sink. Al is lighter, cheaper and easier to process than copper (Cu), which is usually used.

Though the Al-based heat sink has many advantages, it also causes a problem. Specifically, the difference in thermal expansion coefficient between Al and the ceramic substrate (Si3N4) on which a power semiconductor device is mounted becomes larger, compared with Cu. As a result, the stress applied at the time of thermal cycling becomes stronger, causing cracks in the solder used for connecting the ceramic substrate and heat sink.

Therefore, Fuji Electric developed a new solder material. This time, the company used an "improved" SnSb-based solder material in place of a SnAg-based material. With the new solder material, it ensured a reliability high enough for automotive applications while using an Al heat sink.

(Continue to the next page)