Chimei Innolux Corp showcased a touch panel that uses carbon nanotubes (CNTs) as a conductive material at FPD International 2010/Green Device 2010.
The company also embedded the touch panel in a smartphone, etc and demonstrated them.
"It eliminates the need for an etching process for patterning, making it possible to make a touch panel in a simple process," Chimei Innolux said.
There are three manufacturing methods for the CNT-based touch panel. First, two films applied with CNTs are attached to each other by using a spacer (CNT resistive film method). Second, a patterned ITO (indium tin oxide) film and a CNT film are attached to each other (hybrid capacitance method with CNT and ITO). Third, a CNT film is simply attached to a transparent substrate, etc (CNT super-thin film capacitance method).
Chimei Innolux is ready to start volume production of the touch panel by using any of those methods. The CNT film is made by applying CNTs to a PET (polyethylene terephthalate) film.
With the first method, the company prototyped a 4.1-inch touch panel with a resolution of 480 x 800 pixels. Its frame frequency is 125Hz. And its light transmission rate is 74-78% though it differs depending on the substrate.
A touch panel prototyped with the second method has a size of 3.2 inches, a resolution of 320 x 480 pixels, a frame frequency of 85Hz and a light transmission rate of 87%. And a touch panel made with the third method has a size of 3.2 inches, a resolution of 320 x 480 pixels, a frame frequency of 70Hz and a light transmission rate of 87%.
(Continue to the next page)